Thursday, 11 June 2015
Sounding it out.
I managed to get hold of one of the railroad TTS class 47s today. Firstly ok it is the same Lima class 47 bodyshell (which with a little work isnt too bad) but it has a completely new motor and chassis arrangement. Gone is the pancake and in its place is a newer motor with a dcc plug. The best is yet to come however as that is for £80 you get it sound fitted. Im aware they did the 37 a few months back but having heard the 47 i though it would be rude not to get one. The sound is pretty good although i do think doing something with the speaker for better sound would be an improvement but it does sound very good for the money. To be honest i will probably use the chip in something else as ive seen the locos being sold without their sound chips for around £30 so its a case of decoders for £50 which i have to say when on a budget is a very useful way of sound chipping a fleet. Hopefully many more will be released.....
Monday, 1 June 2015
Post showcase review
Well i did say i would start updating this more.....
The lack of any updates has been partially due to the fact ive been busy getting my stock fleet ready for Pengwynn Crossings visit to Burton Upon Trent for the DEMU showcase show. Well its now all back and packed away and i have to say it went rather well all things considered. The main problems seemed to be connected to couplings which wouldnt couple up correctly, Locos still having DCC chips fitted or simple operator error. I have had to withdraw my Jouef Polybulks as they were too light and kept derailing but they will be back for the next time Pengwynn 90 goes out. Ive also got to do a lot work on the locos as there were a few signature class 37s missing but as ive got till October 2016 i think ive got enough time to sort that out. Also hopefully by that time Kernows clay tiger wagon will be out.
Anyway for me the next show is the Chippenham one day show at the end of September. One of our club layouts (Gladstone Road) has been invited but its still far from being finished from its overhaul. The main jobs are on the bridges (one needs painting, the other needs pavements), the station canopy (which is under construction) and the industrial area towards the right hand scenic break. I have the buildings for this but they need to be detailed and "planted". An afternoon would probably knock out a large section of the work required but its a question of finding that afternoon.
The other project im looking at (everytime i look on top of the office roof in the club room) is Llwydd Town. This is due to go out to Calne next January and while it is scenically complete it needs rewiring to DCC along with point motors and also requires legs and boxing up so it doesnt get damaged when being stored or transported to shows. Again a few days would probably get this sorted but its amazing how time dissappears when a deadline is looming.
Anyway im taking a break from modelling for a few days but ive got a few interesting projects on the go and hopefully i will get them on show soon.
The lack of any updates has been partially due to the fact ive been busy getting my stock fleet ready for Pengwynn Crossings visit to Burton Upon Trent for the DEMU showcase show. Well its now all back and packed away and i have to say it went rather well all things considered. The main problems seemed to be connected to couplings which wouldnt couple up correctly, Locos still having DCC chips fitted or simple operator error. I have had to withdraw my Jouef Polybulks as they were too light and kept derailing but they will be back for the next time Pengwynn 90 goes out. Ive also got to do a lot work on the locos as there were a few signature class 37s missing but as ive got till October 2016 i think ive got enough time to sort that out. Also hopefully by that time Kernows clay tiger wagon will be out.
Anyway for me the next show is the Chippenham one day show at the end of September. One of our club layouts (Gladstone Road) has been invited but its still far from being finished from its overhaul. The main jobs are on the bridges (one needs painting, the other needs pavements), the station canopy (which is under construction) and the industrial area towards the right hand scenic break. I have the buildings for this but they need to be detailed and "planted". An afternoon would probably knock out a large section of the work required but its a question of finding that afternoon.
The other project im looking at (everytime i look on top of the office roof in the club room) is Llwydd Town. This is due to go out to Calne next January and while it is scenically complete it needs rewiring to DCC along with point motors and also requires legs and boxing up so it doesnt get damaged when being stored or transported to shows. Again a few days would probably get this sorted but its amazing how time dissappears when a deadline is looming.
Anyway im taking a break from modelling for a few days but ive got a few interesting projects on the go and hopefully i will get them on show soon.
Saturday, 25 April 2015
Going Cornish
Hello to everyone
Its been a while since ive updated this blog. Simply because theres been too much to do and so i havent really thought about this.
Anyway there hasnt been too much to report on any of the layouts as ive been busily getting the stock ready for the DEMU showcase show where i am providing the stock for Pengwynn Crossing. For this show the layout will be back in the sectorisation era so its back to the class 37s.
Ive chosen the period 1992/1993 as there was still quite alot of variety in the stock fleets. There was at one point more 37/4s than 37/5s in the Laira cornish clay pool and so far 37/5s are one area where i am bit short. Ive recently added a r/f red stripe 37/5 but i have no 2 tone grey ones however there are to in the shops to come out as 37673 and 37675 as i already had the nameplates for 675. Ive also done 37413 along with the I/C mainline pair of 37417 and 37420. There is also a brace of 47s and a trio of class 50s.
Ive also recently built up my rolling stock rakes and now have 15 CDA hoppers, four silver bullet wagons and a few polybulks. Its amazing however when you really how very little of the rolling stock is actually finished so with 5 weeks to go it will be out with the airbrush and weathering powders and actually get on with the task. Although they wont all get used ive picked out the best part of 80 odd wagons. That sounds alot but by the time you remove 10 HEA, 15 CDA, 10 PCA wagons then a few seacows and then some spoil wagons then fertiliser vans then fuel oil tanks, 80 odd wagons isnt that many.
I suppose id better get on with it all then!
Its been a while since ive updated this blog. Simply because theres been too much to do and so i havent really thought about this.
Anyway there hasnt been too much to report on any of the layouts as ive been busily getting the stock ready for the DEMU showcase show where i am providing the stock for Pengwynn Crossing. For this show the layout will be back in the sectorisation era so its back to the class 37s.
Ive chosen the period 1992/1993 as there was still quite alot of variety in the stock fleets. There was at one point more 37/4s than 37/5s in the Laira cornish clay pool and so far 37/5s are one area where i am bit short. Ive recently added a r/f red stripe 37/5 but i have no 2 tone grey ones however there are to in the shops to come out as 37673 and 37675 as i already had the nameplates for 675. Ive also done 37413 along with the I/C mainline pair of 37417 and 37420. There is also a brace of 47s and a trio of class 50s.
Ive also recently built up my rolling stock rakes and now have 15 CDA hoppers, four silver bullet wagons and a few polybulks. Its amazing however when you really how very little of the rolling stock is actually finished so with 5 weeks to go it will be out with the airbrush and weathering powders and actually get on with the task. Although they wont all get used ive picked out the best part of 80 odd wagons. That sounds alot but by the time you remove 10 HEA, 15 CDA, 10 PCA wagons then a few seacows and then some spoil wagons then fertiliser vans then fuel oil tanks, 80 odd wagons isnt that many.
I suppose id better get on with it all then!
Monday, 19 January 2015
Its Showtime
Well again too long has gone by since my last post. This is mainly due to it being the start of the show season and also the comedown after christmas.
In the time since the last post the actual level of modelling has been 0. This is mainly due to work and also having so much to do i cant decide what to get first! Even weekends are a struggle. Over the next three months its nearly a show a weekend. This weekend was Calne, next weekend its Eastleigh, then Stafford than im exhibiting at a show in Bornemouth. This ultimately comes to and end with the Bristol show in may.
I did get a chance to give some thing a run out on Sommerford over the weekend including my FGW 150 and a newly purchased Bachmann 166. I thought the 166 looked quite good on Sommerford so its been placed in the early 90s highbridge fleet as a unit under test (they were first delivered in 1992 so around 12 months overlap between them and LHCS). ive also started an HAA MGR rake along with a load more PGA wagons for respray to ARC colours.
Thats its for now but i will try and do a more comprehensive round up towards the end of the week.
In the time since the last post the actual level of modelling has been 0. This is mainly due to work and also having so much to do i cant decide what to get first! Even weekends are a struggle. Over the next three months its nearly a show a weekend. This weekend was Calne, next weekend its Eastleigh, then Stafford than im exhibiting at a show in Bornemouth. This ultimately comes to and end with the Bristol show in may.
I did get a chance to give some thing a run out on Sommerford over the weekend including my FGW 150 and a newly purchased Bachmann 166. I thought the 166 looked quite good on Sommerford so its been placed in the early 90s highbridge fleet as a unit under test (they were first delivered in 1992 so around 12 months overlap between them and LHCS). ive also started an HAA MGR rake along with a load more PGA wagons for respray to ARC colours.
Thats its for now but i will try and do a more comprehensive round up towards the end of the week.
Monday, 12 January 2015
Bringing a layout back from the dead
Well recently as you may know ive become layout manager for a club layout. Ive been working on the platform and canopy as it was sadly past it. The whole platform is being replaced with a new one as it had just too many imperfections. The trouble is the more i look at it the more im not happy with. The road bridge tops are quite poor. The foliaging of the rear wall isnt that good. One bridge doesnt even fit. This is all in addition to all the extra work i need to do to it just to get it to look ok! Its just when you think it will be a quick project it seems to get longer and longer! We will see what happens once the platforms gone in and then appraise what other destruction needs to take place before reconstruction occurs.
Also 150128 has arrived. Im very pleased with it and it runs really nicely. I was convinced the front ploughs were right but they do stick out slightly on the real one and with the supplied buckeye rather than tension lock it does look a lot better. Now all i need is the Realtrack 143 and Hornby 153 to complete the collection!
Richard
Also 150128 has arrived. Im very pleased with it and it runs really nicely. I was convinced the front ploughs were right but they do stick out slightly on the real one and with the supplied buckeye rather than tension lock it does look a lot better. Now all i need is the Realtrack 143 and Hornby 153 to complete the collection!
Richard
Friday, 2 January 2015
Replatforming
Recently ive become layout manager for a club layout called Gladstone Road. The layout is a simple through station set in the late 80s early 90s. The trouble is the layout has been unloved for a while and it needs some basic refubishment.
Most of the jobs are fairly basic but one big job is the platform and the associated canopy. The canopy itself is made using some of the early airfix kits. I know dapol have reintroduced this kit but its not as nicely moulded as the early ones so airfix ones it is. ive got a few kits and im slowly building a new one but the main problem is the platform. Its had so many things stuck to it over the years that its got lots of glue marks and has a few holes and other imperfections. The more i look the worse it seems so im wonder if a new main platform is needed. It would follow my usual construction techniques of peco sides with wills sheet tops. If the current platform is the standard width then it will be very easy as of yet though i have measured one up to see what its like!
The other jobs are minor repair jobs and cleaning jobs as its been in store for nearly 2 years but i would like to see it back out on to the circuit some time next year (2016) and hopefully a magazine article will also have been written by that time.
Oh yes and Llwydd is still there, i just havent done anything else to it yet but the plan has been made for it!
Most of the jobs are fairly basic but one big job is the platform and the associated canopy. The canopy itself is made using some of the early airfix kits. I know dapol have reintroduced this kit but its not as nicely moulded as the early ones so airfix ones it is. ive got a few kits and im slowly building a new one but the main problem is the platform. Its had so many things stuck to it over the years that its got lots of glue marks and has a few holes and other imperfections. The more i look the worse it seems so im wonder if a new main platform is needed. It would follow my usual construction techniques of peco sides with wills sheet tops. If the current platform is the standard width then it will be very easy as of yet though i have measured one up to see what its like!
The other jobs are minor repair jobs and cleaning jobs as its been in store for nearly 2 years but i would like to see it back out on to the circuit some time next year (2016) and hopefully a magazine article will also have been written by that time.
Oh yes and Llwydd is still there, i just havent done anything else to it yet but the plan has been made for it!
Subscribe to:
Posts (Atom)